This is a case for the corne/crkbd split keyboard which features magnetic attachment between the halves and a low profile design despite capacity for a 1150mAh battery. The design is intended to be printed in its normal orientation rather than upside down, so the columns that receive the case screws extend all the way to the build plate and must be carefully trimmed with flush cutters. These columns are radiused at their base to help prevent them snapping up when removing supports. This case is designed to work with this lipo cell which is only 4mm thick. Also, the case is designed to fit the nice!view rather than a typical OLED screen. The screws for this case are M2.5x8mm with countersunk heads. The battery connectors are these, because they are exceedingly flat. The nice!view screens are mounted with two laters (2mm) of this double-sided tape to get the right offset between the PCB and the top of the case. The nice!nano controller and the reset button need to be mounted to the bottom of the PCB for everything to fit correctly. Lastly, the stabilizing pillar between the reset button and on/off switch needs to be trimmed to fit with flush cutters depending on whether it touches the microcontroller.